It's never needed that as long as I've known about it. Last time I looked at them, the Collabora open source version needed compiled. I have Collabora Online 4.0.4 installed with Collabora Online - Built-in CODE Server 6.4.Said in Onlyoffice vs Collabora in said in Onlyoffice vs Collabora in said in Onlyoffice vs Collabora in said in Onlyoffice vs Collabora in said in Onlyoffice vs Collabora in Nextcloud: I did set overwrite protocol in the nextcould settings but that does not have any effect on it ether.Īlso updated to NextCloud 21.0.1 but that made no difference. And it almost works where it not for a small oversight. If you choose to use the internal server (which I want because this is a setup for light use) It understandably does not give you any other configuration options. I have been unable to find any setting or config file where I can correct this. I am experiencing the same mixed content issue.Ĭontent Security Policy: The page’s settings blocked the loading of a resource at (“connect-src”).īlocked loading mixed active content “ If I attempt to reach these URLs over https there is a response and Collabora does attempt to load but there are simply more mixed content failures. So how do I get the Collabora code server to work via https>http apache proxy or is it not possible with Nextcloud Snap? On inspecting the Firefox console output it is showing mixed content errors:Ĭontent Security Policy: The page's settings blocked the loading of a resource at ("connect-src"). BTW, using Onlyoffice & Community Document Server works OK. I am guessing it is either an https>http issue or the proxy but so far I am stumped. I have been doing some searching but can't find a solution. Switching back to built in code server is the same fault again. Noted that in NC settings it shows a tick and Collabora online server is still reachable. However if I configure and access via an Apache Proxy on 192.168.1.12 (https>http) ie, nextcloud.my.domain, NC works fine but opening a document gives me a white page. If I configure and access NC as it works ok and so does Collabora. In NC settings it shows a tick and Collabora online server as reachable. I have SNAP NC 19.0.3 installed with Collabora built in code server 4.2.8 and Collabora online 3.7.4.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |